Cheat Engine

lostprophets

I got a pcchips p55g motherboard and a 2gb ddr2 800Mhz ram but when it boots it selects 667 as default, in manual it says i need to change it to unlinked and then set it to 800Mhz but every time i do that when i go into windows it ultra lagss.... any1 know a solution?

Honda · Posted: Thu Jun 25, 2009 11:08 pm Post subject:

Did you change it in your bios?

lostprophets · Posted: Thu Jun 25, 2009 11:27 pm Post subject:

yes, i changed it to 800Mhz and it ultralaggd on windows, screen freezed

hcavolsdsadgadsg · Posted: Thu Jun 25, 2009 11:42 pm Post subject:

check to make sure you set the voltage and timings correctly as well.

lostprophets · Posted: Fri Jun 26, 2009 10:16 pm Post subject:

i got a new memory of a GB KVR800D2N6/1G PC2-6400 and it still shows the same problem, the voltage on the memory says 1.8v and the min. voltage that is on my mother board is 1.85v, i changed it to the min voltage and changed the mem frequency to 800Mhz, it worked for a good time, but when i open a lot of things it freezes.

Haswell · Posted: Fri Jun 26, 2009 10:55 pm Post subject:

Can we have specs on the mobo?

lostprophets · Posted: Sat Jun 27, 2009 12:38 am Post subject:

Specs: http://www.pcchips.com.tw/PCCWebSite/Products/ProductsDetail.aspx?detailid=406&CategoryID=1&DetailName=Specification&MenuID=7&LanID=0

hcavolsdsadgadsg · Posted: Sat Jun 27, 2009 2:59 am Post subject:

lostprophets · Posted: Sat Jun 27, 2009 4:39 am Post subject:

dam i didnt found my memory on the memory QVL list of my motherboard so i guess i will need to get a 667Mhz memory since the 800 Mhz Qualified Memorys are hard to get ._., thx for all help.