| View previous topic :: View next topic |
| Author |
Message |
Woza
Newbie cheater
![]() Reputation: 0
Joined: 08 Sep 2012
Posts: 12
|
 Posted: Wed Sep 04, 2013 1:53 pm Post subject: Problem with writeFloat |
 |
|
| Code: | addys = {}
addys.player = "66 0F D6 AB 00 01 00 00 F3 0F 7E 6E 18 66 0F D6 AB 08 01 00 00" -- accesses the players position
player = {}
player.x = 0xFC -- offsets, these ARE correct
player.y = 0x104
player.z = 0x10C
function debugger_onBreakpoint()
if (EIP == addys.player) then
writeFloat(EBX+player.x, 2.0) -- does work
writeFloat(EBX+player.y, 2.0) -- doesn't work
writeFloat(EBX+player.z, 2.0) -- doesn't work
readFloat(EBX+player.y) -- this would return 2 but my actual position isnt changed
end
debug_continueFromBreakpoint(co_run) -- continue execution
end
for k,v in pairs(addys) do
addys[k] = AOBScan(v)
if addys[k] == nil then print("Error: couldnt find AOB " .. v) else addys[k] = tonumber(addys[k][0],16)
end
end
print("Found AOBs")
debugProcess()
debug_setBreakpoint(addys.player) |
This is my code which is supposed to lock the player. However only my X coordinate is locked and other than that I can move freely. I have checked the offsets, they should be correct. print(EBX) on the debug loop only returns 1 address. I can't figure it out.
Edit:
Darn, this is probably in the wrong section :/
|
|
| Back to top |
|
 |
Dark Byte
Site Admin
 Reputation: 470
Joined: 09 May 2003
Posts: 25785
Location: The netherlands
|
| Posted: Wed Sep 04, 2013 2:58 pm Post subject: |
|
|
Perhaps the instructions after the breakpoint set the y and z coordinates
E.g. if your breakpoint is at the location that writes your x coordinate, then it's likely the following instructions write y and z, overwriting your modified coordinates
_________________
Do not ask me about online cheats. I don't know any and wont help finding them.
Like my help? Join me on Patreon so i can keep helping |
|
| Back to top |
|
|
Woza
Newbie cheater
![]() Reputation: 0
Joined: 08 Sep 2012
Posts: 12
|
| Posted: Thu Sep 05, 2013 8:56 am Post subject: |
|
|
Yes, that was the problem. Thank you very much! 
|
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
