Cheat Engine

Fresco · Posted: Sat Feb 25, 2012 2:06 pm Post subject: tracking a jump path

in my code there are lots of cmp's je's jne's etc...

if at address 0000aaaa the register eax=00abcdf:
i want the tracer to trace all instructions till this address 0000bbbb

how do i do that ?

Dark Byte · Posted: Sat Feb 25, 2012 2:26 pm Post subject:

Set a break and trace breakpoint at 0000aaaa and set as (endcondition EIP==0x0000bbbb)

Then rightclick the breakpoint and choose break condition, or go to the breakpointlist, rightclick the breakpoint there, and set as break condition (EAX==0x00abcdef)

If the breakpoint hits before you can set the breakcondition pause the process first (e.g. bp one or two instructions before)

Fresco · Posted: Sun Feb 26, 2012 8:26 am Post subject:

it works thanks Smile

I have another question ...
How do I set it to break and trace when EAX is NOT equal to 00abcdef ?

Dark Byte · Posted: Sun Feb 26, 2012 8:43 am Post subject:

instead of == use ~=

Fresco · Posted: Sun Feb 26, 2012 9:03 am Post subject:

as always works. thanks

what about

EAX is NOT equal to 00abcdef
EAX is NOT equal to 00abcabc
EBX is equal to 000123ab

how do i put multiple conditions ?

is there any manual or something ... not to bother anymore ...

Dark Byte · Posted: Sun Feb 26, 2012 9:28 am Post subject:

check generic lua documentation and the ce doc

anyhow

(EAX~=0x00abcdef ) and (EAX~=0x00abcabc) and (EBX==0x000123ab)