Cheat Engine

bloodwi11 · How do I cheat? Reputation: 0 Joined: 18 May 2007 Posts: 3

alright so i did some searching but i cant seem to find what i'm looking for, all I'm trying to figure out is how to replace a specific value in a file permanently so when the .exe starts it already has the set value. Please help and thank you in advance

anameaddict · Posted: Mon Jul 23, 2007 9:33 pm Post subject:

Cheat table?Eh...Make a trainer?
Or you could just edit the .exe...But that might take some know how :\

bloodwi11 · How do I cheat? Reputation: 0 Joined: 18 May 2007 Posts: 3

Any suggestions of software to rewrite it?

anameaddict · Posted: Mon Jul 23, 2007 9:36 pm Post subject:

Sorry but not that I currently know of.

gamesguru · Posted: Mon Jul 23, 2007 9:40 pm Post subject:

OLLYDBG, edit the value you want, this can be done by: Right Click>binary>edit and change the hex dump (corresponds to its value). Click ok. Then back in the main view right click>Copy To Executable>Selection (or if you edit mutiple use All). A new window should pop up, right click in that and Save To File. Boom, your done.

bloodwi11 · How do I cheat? Reputation: 0 Joined: 18 May 2007 Posts: 3

thank you very much

Labyrnth · Moderator Reputation: 10 Joined: 28 Nov 2006 Posts: 6300

bloodwi11 · How do I cheat? Reputation: 0 Joined: 18 May 2007 Posts: 3

The problem is i cant get it into the codelist, i dont have a pointer of a sort to set in the code list, and im not good at picking apart the addresses that write it, i know it has 5 addresses that write it at the Startup of the program, but it runs them once and its done.