Cheat Engine

paul44 · Last edited by paul44 on Sat Sep 16, 2023 3:09 am; edited 1 time in total

I've recently been working with DBVM in combo with MW REM (incl H1-Mod).
Using 'Find out which addresses...' do not give any problems, but sofar I fail to make use of the BP feature. Either:
a. only 1 option 'set specific BP' shows; and using that option will kill the game instantly
b. or it does show up - although atm i have no clue when/how - but enabling the BP only "lasts for about 5 secs", and then it auto-disables ?! Iow i can not use BPs at all...

Any suggestions I can try out here ?

some info: [ https://ibb.co/rtQkY50 ] (2 pics)

Dark Byte · Posted: Sun Sep 03, 2023 12:32 am Post subject:

Is the debugger interface set to DBVM debugger interface ?

paul44 · Posted: Mon Sep 04, 2023 12:10 am Post subject: debugger selected...

^I'm assuming you are referring to v7.4+ 'DBVM-level' debugger (instead of kernelmode debugger) ?

anywho: fired up all versions yesterday evening, and learned about this new option in v7.4+. So tried it wit CE v7.5, and this seems to work fine.
=> I will do some practical evaluation this week, and update accordingly...

paul44

I performed some extended testing with DBVM-level debugger; and everything works as expected (using v7.4 here). Consider topic closed...

For completeness sake:
if i enable any of them 3 'Extra' options ('query mem region routines', etc), this will always invoke/load 'dbk64' upon launching CE ?!
Did some searching on them, but could not find anything helpful. So, when/where would one use (any of) these 3 features ?

And: is it possible to "unload" dbk64 driver during the same pc_run session, or best always reboot ?
(Kernelmoduleunloader will not do btw; running this usually will bsod my pc evt)