Cheat Engine

MegaTorch · How do I cheat? Reputation: 0 Joined: 19 Feb 2016 Posts: 6

Hi all! I am in situation where I need to find some value(ID) placed in an object. Well, every time I refresh game window, the object is generated somewhere else in memeory. So I need to find a value that is somewhere in code, and after next scan it is somewhere else.

I think I need to create some scan tabs, do the scans and compare the values, and get only those which are repeated?(I dont know if its good word - my eng isnt best Razz

). I got like 60mil of addreses at start, I think there should be used loop in loop to compare every value with another one in other tab(and then I will repeat it some times to get less results) - Is it possbile to do it (for that amount of addresses)?

So help me with lua code thanks !

Dark Byte · Posted: Tue Feb 23, 2016 3:01 am Post subject:

comparing tabs isn't posible, but you can save the results, and compare against them in an subsequent scan.

so if you are at a repeatable state, save the results
then next time the value is the same, use "compare to saved scan", select the scan, and then do an unchanged scan.

MegaTorch · How do I cheat? Reputation: 0 Joined: 19 Feb 2016 Posts: 6

Hey, I am looking for those functions in whole program but I can't really find it.

How to save scanresults? After scan I got message Found: 85,161,984, but how to save those addresses? The Basic save option(ctrl+s/ctrl+alt+s) saves only the things from the lower table (Should I add them all there somehow?).

Also I can't find the 'compare to saved scan' thing , there's only 'compare to first scan'.

Sorry if thats noob question, but I really can't find those Sad

hhhuut · Posted: Tue Feb 23, 2016 11:05 am Post subject:

File -> Save current scanresults Wink

MegaTorch · How do I cheat? Reputation: 0 Joined: 19 Feb 2016 Posts: 6

It's locked (gray color). Even after scan :/

++METHOS · Posted: Tue Feb 23, 2016 12:54 pm Post subject:

Do another scan (next scan).

Dark Byte · Posted: Tue Feb 23, 2016 1:00 pm Post subject:

It's grey because the first scan is saved anyhow

MegaTorch · How do I cheat? Reputation: 0 Joined: 19 Feb 2016 Posts: 6

Dark Byte · Posted: Wed Feb 24, 2016 4:01 am Post subject:

compared to saved scan enters a special state.
From there you compare the current addresslist to the saved state values.

Let's say you saved the state after a scan where the value was 100
When you enter compare to saved scan it will compare the current value to the saved scan value (100)

You can then say that the value is lower (decreased), higher (increased) , changed or unchanged compared to the 100.

MegaTorch · How do I cheat? Reputation: 0 Joined: 19 Feb 2016 Posts: 6

In my problem the value I am looking for is on some address in the saved adresslist and on another address on the new addresslist. Do the compare option compares every single value from the saved addresslist with every value from the new addresslist? (This operation I think would take more time to do, so I am not sure if it works like I said)

Dark Byte · Posted: Wed Feb 24, 2016 9:10 am Post subject:

no. there is no way to link completely different addresses