Cheat Engine

Stormsoul · Newbie cheater Reputation: 0 Joined: 12 May 2011 Posts: 21

I've been doing pointer scans for a while now and have never had this problem. I have these 4 addresses:
00448A00
00448A01
00448A02
00448A38

I did the scan with the first one and everything was good. However the second and third ones when I do the scan, under Points to: it shows the first address not the one I used. It does this for the second and third one, but the 4th one when I scan, under Points to: it shows the right one.

Why after the scan does it revert back to the first address for those other two and not the 4th one? How do I make it so that this doesn't happen? I tried changing the "threads scanning" and "Max level" with no luck. Any help would be appreciated. Thanks.

Dark Byte · Posted: Sat Dec 19, 2015 6:31 pm Post subject:

don't use compressed pointerscan files, and/or make sure that alignment is turned off

Also, instead of pointerscanning for the other addresses, just do one single pointerscan for 00448A00 and then just manually adjust the last offset so it points to the address you want. The distance is small enough that they are likely in the same group