Cheat Engine

zxczxc369 · Newbie cheater Reputation: 0 Joined: 18 Jun 2009 Posts: 18

i keep getting error
here the steps i do
1.scan the value 1st ( exact value with 4 bytes)
2.press next value if still have few addresses
3.once having 1 address left i double click to put it on bottom
4.right click on it and click what it write to this address
5.change the value again
6.the line show out
7.click for more info
8.press new scan and tick hex and enter the number
9.1 address show out and i double click to put in on bottom
10.right click the pointer address and click what it access to this address
11.click next value and nw it show 2 lines out ..
what did i do wrong ??
i use cheat engine 6

Smanettone83 · Posted: Mon Mar 07, 2011 7:24 am Post subject:

see this topic

forum.cheatengine.org/viewtopic.php?t=533230

zxczxc369 · Newbie cheater Reputation: 0 Joined: 18 Jun 2009 Posts: 18

i did see this youtube alrdy
but still doesnt work for me

it just give me 2 addresses instead of 1

zxczxc369 · Newbie cheater Reputation: 0 Joined: 18 Jun 2009 Posts: 18

any1 can help ?

btw: does cheat engine 6 have [all] for the memory scan options

Geri · Moderator Reputation: 111 Joined: 05 Feb 2010 Posts: 5627

zxczxc369 · Newbie cheater Reputation: 0 Joined: 18 Jun 2009 Posts: 18

btw
for the 2nd pointer onwards
shld i click look what write in this address
or click look what access in this address

and when go in either of the choices

it say

Geri · Moderator Reputation: 111 Joined: 05 Feb 2010 Posts: 5627

It is not a problem if there are more codes accessing/writing to the value. The only important thing is to find the base address of the structure as pointers are usually pointing to the base address, which is in most cases the register between the brackets [ ] as the CE tutorial says.

zxczxc369 · Newbie cheater Reputation: 0 Joined: 18 Jun 2009 Posts: 18

zzzz not ansing my qn.

the problems is i dono what 1 to click
write or access

and sometime i dono which 1
i press change value nth come out
if not 2 line come out instead 1

Geri · Moderator Reputation: 111 Joined: 05 Feb 2010 Posts: 5627

If you use "access", it will least all codes that are accessing to the value. This that are reading it and those that are writing to it too.

Does it matter if you have 2 lines of codes? Just check both of them and probably you will see that the address for the pointer is the same in both codes. At least in most cases.