Cheat Engine

[9077]

I got a pscaning for whole night and her tell me
' only first 10,000,000 will be displayed, rescan will affecte all results'
I rescan, my screen is flashing a moment later, and then shutdown.
I push the power off and push it on, BSOD,
what should I do, I got 150,000,000+ entries in .ptr


I try 3 modes to debug the game, NO ANSWERs?
the game is always running in Ring0. and other suguests?

[Dacnomania]

There are different methods to finding a pointer, one method only takes about two minutes.

I'll explain it:

Find your value, let's say ammo.
Right click on that address "Find out what writes to this address".
Now go back in game, shoot a bullet. Minimize it.
The new window that popped up when you selected "Find out what writes to this address" Will now contain hopefully just one, or more opcodes.

Let's say you get something like this: mov [esp+18],ecx

Write down the 18, or remember it.
Click on more information:

Then write down(or remember)
The value of the pointer needed to find this address is probably 00288390 (for example)

Write down the "00288390"

Now close the debugger, and do a new 4byte scan.
Tick the Hex box, now paste 00288390 into it.

Do a search.

Hopefully you only find one address, you can find hundreds though.

Assuming you've found one, now take the address (Not the value, the value you just searched for will be the value of the address.

So let's say the address is 040394FC.

Click on the button "Add address manually", Check the 'Pointer' box.
Put in "040394FC" and remember the number I said remember or write down from "mov [esp+18],ecx" So put in 18 into the offset [hex] box.

Now click ok.

If you did this correctly the pointer you just added will be the same as the ammo.

Basically this takes about 2 minutes, perhaps more, but in the end it's extremely faster than doing a pointer scan.

Hope I enlightened you here.

[9077]