Cheat Engine

kaysakado · How do I cheat? Reputation: 0 Joined: 02 Mar 2008 Posts: 5

...you do something?

Also, completely unrelated, has anyone actually read the legal notice? I wasn't going to, but then I saw "go to jail with a guy named Big Bubba" and I decided to read it.

h4ckz0r's twisted soul

Dark Byte · Posted: Mon Mar 03, 2008 6:45 am Post subject:

find an address that is being accessed when you do that thing.
Then add it to the list, rightlick and choose "Find out what accesses this address"
That will then give you a list of assembler code's that have accesses that address. So effectively a place to start looking

kaysakado · How do I cheat? Reputation: 0 Joined: 02 Mar 2008 Posts: 5

I know, but when I tried that, it only gave me part of the code that run during that time. I need a way to find all the code that gets run.

Labyrnth · Moderator Reputation: 10 Joined: 28 Nov 2006 Posts: 6301

The instruction you break on is directly involved with what your hacking.
If your looking for a whole routine or something, it will be above and below where you break.

kaysakado · How do I cheat? Reputation: 0 Joined: 02 Mar 2008 Posts: 5

I suppose so, but I'm not sure this would work in this case, because the code I'm getting is code simply writing to the log, it has nothing to do with what's actually happening, but I'll try anyways.

Labyrnth · Moderator Reputation: 10 Joined: 28 Nov 2006 Posts: 6301

Dark Byte · Posted: Mon Mar 03, 2008 4:27 pm Post subject:

try finding the start and then do a "break and trace xxx times"
Then when that code gets executed it'll step through the code for you the specified times and stores the registers

kaysakado · How do I cheat? Reputation: 0 Joined: 02 Mar 2008 Posts: 5

OK, I'll try that.

EDIT: It worked. Thanks!