Cheat Engine

Caliber

I am trying to complete a small tool to help me with some of the work I do. One of the tasks that my program will do is to disassemble code at the location I request (similar to when you press the Disassemble Buttons in CE).

At any rate, did you use the ollydbg .dll (compiled) to help you with disassembly? I cannot compile this .dll but I notice that the precompiled version I got (and also the one that is inside CE) cannot debug SSE instructions such as

movss dword[eax+$40], xmm0

and etc. Did you compile the olly.dll yourself. Is that .dll the one you are using within CE? do you have a newer one already precompiled? ollydbg seems to disassemble SSE fine with version 1.10 but i cannot find a .dll to use from that version to allow me to disassemble in my own programs.

i do not wish to write a disassembler from scratch! what info can you give me? do you know of a source for a precompiled .dll for olly that will disassemble all instructions (SSE, etc.)?

best,
Caliber

Flyte · Posted: Sun Dec 23, 2007 5:22 pm Post subject:

The disassembler in CE was written from scratch in Delphi. There is a standalone dll that you can request from Dark Byte if you are just using it for something personal.

Dark Byte · Posted: Sun Dec 23, 2007 6:03 pm Post subject:

no, I didn't use anything from olly for my disassembler.
but I did fix the movss instruction handling for the new version.
I can make a dll out of it, I have the project configured a while ago to only make a disassembler dll, but it's been a while that I touched it so I will first have to do some small fixes/changes before it can be compiled as standalone dll again

Caliber · Posted: Sun Dec 23, 2007 8:57 pm Post subject: