Cheat Engine

renomous

okay so every day i have to clear 16 stages
each one have different requirements
any idea how can i find it
i searched for how many i have killed found adress then find out what access this adress then i trace the code
the trace only work when i kill next one if i fail to kill it it dosnt load trace ( break and trace instruction that i mean)

++METHOS · Posted: Fri Mar 10, 2017 4:05 am Post subject:

If requirements are met by number of kills/points etc., then finding the appropriate value and checking to see what is accessing its address, should give you a good starting point. Since the value in question has to be constantly checked against, presumably, to determine if/when the stage requirement has been met, then there should be an instruction that is reading that value to check for that (ideally).

If, however, the stage requirement is unknown, then using ultimap may be the way to go so that you can find whatever flag gets changed each time the requirement is met.

renomous · Posted: Fri Mar 10, 2017 6:50 am Post subject:

1: i didnt get from where to start explain me agian please i so badly need to hack it lol
2: isnt ultimap for finding buttons you press or somthing like that
it count codes that have been executed
how ultimap can help me to find requirements

pellik · Posted: Fri Mar 10, 2017 8:49 am Post subject:

So you found some instructions that only run to update the stored number of enemies killed? Sounds like you searched for what writes to the address not what accesses the address.

renomous · Posted: Fri Mar 10, 2017 10:22 am Post subject:

yes lol sorry so what now
how can i hack it
come one help me

Csimbi · Posted: Fri Mar 10, 2017 1:27 pm Post subject:

You need to find the code that reads the value.
Then, you just load the required value into the register before the required value is compared to the current value.